Open a firmware
The official firmware ships as an update WAV. GrainKontrol decodes it to recover the binary and its wavetables. Community firmwares open the same way, as .wav or .bin.
The built-in firmware is the official Beads firmware, decoded from Émilie Gillet's beads.wav (MD5 c13a13056a77a04808ebb12ed7e080c7). It is the one tested on a module.
Loaded firmware
- Name
- —
- Source
- —
- Size
- —
- CRC32
- —
- Official
- —
- Wavetables
- —
Wavetables
12 banks × 16 waveforms × 256 samples. The module normalizes amplitude and removes DC offset.
Bank 1 · wave 1
originalPrepare the update
- Base
- —
- Wavetables
- —
How to flash
- The official firmware is built in: flashing it again always lets you roll back. The update never touches the bootloader.
- Patch your audio interface output into IN L. Turn off effects, EQ and volume normalization in your player.
- Power up the rack while holding FREEZE. FREEZE and SEED blink alternately.
- Start playback. Set the level with the volume slider here, or with the TIME knob, which acts as input gain in this mode. Watch the color LED of the recording quality button: it is the level meter and should glow yellow to orange. Plain green is too weak, red is too hot. If it stays green with TIME fully clockwise, raise your audio interface output.
- Let playback run to the end. The module restarts on the new firmware by itself.
Reading the LEDs
Library
Stored in this browser, on this computer.
Firmwares
Wavetable sets
About GrainKontrol
GrainKontrol is a free, offline editor for the Beads texture synthesizer. Open the firmware, build your own wavetables, and send the update to the module from your browser. Everything runs on your computer: nothing is sent online.
- Version
- —
- Tested
- On a Beads module, with the official firmware
- Made by
- PLASMAKULT · designed by dAtAkult, coded with Claude Code
Feedback
Found a bug, or missing a feature? Use Report a bug at the bottom of the page: the email comes pre-filled with the version, the loaded firmware and your browser.
What changed in each version: see the release notes at the bottom of the Firmware tab.